Parallel ATA

interface standard for the connection of storage devices

Parallel ATA is a way to connect storage devices, such as Hard disks, solid-state drives, and CD-ROM drives inside personal computers. The standard is maintained by X3/INCITS committee T13.

ATA/ATAPI connector
80 pin and 40 pin cables to connect the drives

It used to be called Advanced Technology Attachment with Packet Interface (ATA/ATAPI). ATA/ATAPI is the result of a long history of development. It is an evolution of the AT Attachment Interface, which was itself evolved in several stages from Western Digital's original Integrated Drive Electronics interface. As a result, many near-synonyms for ATA/ATAPI and its previous incarnations exist, including abbreviations such as IDE which are still in common informal use. With the market introduction of Serial ATA in 2003, the original ATA was retroactively renamed Parallel ATA (PATA).

Parallel ATA standards allow cable lengths up to only 18 inches (46 centimeters). Because of this length limit the technology normally appears as an internal computer storage interface. For many years ATA provided the most common and the least expensive interface for this application. As of 2007, it has largely been replaced by Serial ATA (SATA) in new systems. Older computers based on Parallel ATA are still widely-used in embedded and industrial applications.

Other websites