Magnetic reluctance, or magnetic resistance, is a measurement used in the analysis of magnetic circuits. It is like resistance in an electrical circuit, but rather than dissipating magnetic energy it stores magnetic energy. As an electric field causes an electric current to follow the path of least resistance, a magnetic field causes magnetic flux to follow the path of least magnetic reluctance. It is a scalar, extensive quantity, like electrical resistance.
Conventional Magnetic Circuits
Phasor Magnetic Circuits
Gyrator-capacitor model variables
Reluctance is usually represented by ℜ.
The term was coined in May 1888 by Oliver Heaviside. The notion of “magnetic resistance” was first mentioned by James Joule and the term "magnetomotive force” (MMF) was first named by Bosanquet. The idea for a magnetic flux law, similar to Ohm's law for closed electric circuits, is attributed to H. Rowland.
The total reluctance is equal to the ratio of the "magnetomotive force” (MMF) in a passive magnetic circuit to the magnetic flux in this circuit. In an AC field, the reluctance is the ratio of the amplitude values for a sinusoidal MMF and magnetic flux. (see phasors)
The definition can be expressed as:
- ("R") is the reluctance in ampere-turns per weber (a unit that is equivalent to turns per henry). "Turns" refers to the winding number of an electrical conductor comprising an inductor.
- ("F") is the magnetomotive force (MMF) in ampere-turns
- Φ ("Phi") is the magnetic flux in webers.
Magnetic flux always forms a closed loop, as described by Maxwell's equations, but the path of the loop depends on the reluctance of the surrounding materials. It is concentrated around the path of least reluctance. Air and vacuum have high reluctance. Easily magnetized materials such as soft iron have low reluctance. The concentration of flux in low-reluctance materials forms strong temporary poles and causes mechanical forces that tend to move the materials towards regions of higher flux so it is always an attractive force (pull).
The reluctance of a uniform magnetic circuit can be calculated as:
- l is the length of the circuit in metres
- is the permeability of free space, equal to henry per metre
- is the relative magnetic permeability of the material (dimensionless)
- is the permeability of the material ( )
- A is the cross-sectional area of the circuit in square metres
The inverse of reluctance is called permeance.
- Air gaps can be created in the cores of certain transformers to reduce the effects of saturation. This increases the reluctance of the magnetic circuit, and enables it to store more energy before core saturation. This effect is also used in the flyback transformer.
- Variation of reluctance is the principle behind the reluctance motor (or the variable reluctance generator) and the Alexanderson alternator. In other words, the reluctance forces seek the most aligned magnetic circuit and a small air gap distance.
- Multimedia loudspeakers are typically shielded magnetically, in order to reduce magnetic interference they make on televisions and other CRTs. The speaker magnet is covered with a material such as soft iron to minimize the stray magnetic field.
Reluctance can also be applied to:
- Heaviside O., Electrical Papers, Vol 2 – L.; N.Y.: Macmillan, 1892, p.166
- Joule J., Scientific Papers, vol 1 – 1884, p.36
- Bosanquet, Phil. Mag., vol 15, 1883, p.205
- Rowland H., Phil. Mag. (4), vol 46, 1873, p.140